Yealink Configuration

This procedures defines when the Yealink phone should register the phone as an endpoint within UNP.

1. Log into the web configuration interface for your phone.

2. Go to Features > Action URL.

3. For the listed actions, identify those for which Yealink should use to register the phone.

   It is suggested you select at least IP Changed, Setup Completed, Registered, and Autop Finish. Note that not all of these actions are available for every phone.

4. For the selected actions, enter the following string into the value fields (replacing [ip_address] with your UNP IP address):

   http://[ip_address]/YealinkListener?mac=$mac&firmware=$firmware&model=$model

When any of the selected events occur, Yealink will communicate with UNP using the provided string. At that point, UNP will recognize the phone as an endpoint, and it will be named named in the format:

Yealink <Phone Model> <MAC address>

See Assign a custom name for easier identification for more information.

To send UNP notification text and images to your Yealink phones, you must configure the Remote Control feature to accept communications from UNP.

1. Log into the web configuration interface for your phone.

2. Go to Features > Remote Control.

3. For Push XML Server IP Address, enter the IP address of your UNP server. Alternatively, you can enter the string any, which means that the phone will accept information from any IP address. If you leave this field empty, the phone will reject pushes from all sources.

4. For Username and Password, enter credentials for connecting to the phone. You will enter these credentials into the Yealink settings within UNP. Ensure that all Yealink phones use the same credentials.

5. For Block XML in Calling, set to Disabled.

   For Action URI Allow IP List, enter the IP address of your UNP server. You can enter several IP addresses, if needed, in a comma-separated list.

6. All other fields can be set per your requirements.

• Set credentials – Define the credentials used to connect to the Yealink phones, as set up in their web configuration.

  1. Go to Configuration > Phone Systems > Yealink.

  2. Select the Settings tab and enter the credentials in the Yealink Username and Password fields.

When you are creating or editing notifications, you can send information to your Yealink phones by selecting the proper endpoint in the Endpoint & Contact Selection section.

• For text and images, select the endpoint recognized, as described in the section Register your Yealink phones as endpoints.

• For audio, you can use a related process as described in the section Configure Yealink SIP phones.

You can configure Yealink Line Keys to interact with UNP.

1. Create phone services in UNP:

   • Phone Service Dialer – See Phone service dialers that dial a number.

   • Phone Service Trigger – See Phone service triggers that send a notification

2. Configure your Yealink phone Line Keys – See Yealink Phone Services.